Specifications
Wavespeed/S Configuration Guide (90000407 Rev. C) – Page 6
SPP Server Configuration
1. Power the unit and connect it to a serial port on your
computer.
2. Place both units in configuration mode by sliding the
three-position switch to the far right, away from the
power connector.
3. Launch the WvsdpCfg configuration utility.
4. In the first screen, select SPP Server in the Device
Function box.
Select COM Port
5. Specify the COM port to which the local Wavespeed/S
device is attached. The COM port can be selected in
one of two ways.
a. If you know the COM port, select that port from
the combo box and click Set COM Port Selection.
b. Or, if you are unsure which port the local device is
attached to, click Auto Detect.
6. After the Configuration Wizard has verified that it can
communicate with the local device, it displays the
current configuration and Bluetooth device address.
Click Next to configure the local device.
Configure Local Port
The next step is to specify the local device’s port emulation set-
tings and type. In this step, you specify how the Wavespeed/S
device communicates over the COM port to the device to which
it is attached. In other words, if your application currently sends
data at 9600 baud with 8 data bits, 1 stop bit, no parity, and
software flow control, you need to specify those settings for the
Wavespeed/S. In addition, you must determine if the device at-
tached to the Wavespeed/S is a DTE or DCE device. The
Wavespeed/S device must be set to the device type that is oppo-
site of the device to which it will be attached. That is, if your
device is DTE, select DCE for the Wavespeed/S.
7. For each port setting, select the desired value.
8. Clicking Advanced allows you to set the following
features:
SPP Connect Output Select: The SPP Connection
Status Signal is a unique feature that raises the
voltage level of Pin 1 (carrier detect) when a SPP
connection is present on the Wavespeed/S.
Application developers can determine if a
connection is available simply by checking the
status of Pin1. (This feature is only available when
the unit is configured as a DCE device.)