Specifications

Wavespeed/S Configuration Guide (90000407 Rev. C) – Page 5
10. The Configuration Wizard automatically notifies you
that the bonding was successful. If the procedure fails,
retry the bonding process.
11. Click Next when bonding is complete.
Configure Local Port Settings
The next step is to specify the local device’s port emulation
settings and type. In this step, you will specify how the
Wavespeed/S device communicates over the COM port to the
device it is attached to. In other words, if your application cur-
rently sends data at 9600 baud with 8 data bits, 1 stop bit, no
parity, and software flow control, you need to specify those
settings for the Wavespeed/S. In addition, you must determine
if the device attached to the Wavespeed/S is a DTE or DCE
device. The Wavespeed/S device must be set to the device type
that is opposite of the device to which it will be attached. That
is, if your device is DTE, select DCE for the Wavespeed/S.
12. For each port setting, select the desired value.
13. Clicking Advanced allows you to set the following:
SPP Connect Output Select: The SPP
Connection Status Signal is a unique feature that
raises the voltage level of Pin 1 (carrier detect)
when a SPP connection is present on the
Wavespeed/S. Application developers can see if a
connection is available simply by checking the
status of Pin 1. This feature is available when the
unit is configured as a DCE device.
14. When all settings are specified, click Set Port
Configuration to send the settings to the local device.
15. After viewing the confirmation message, click Next.
Configure Remote Device Port Settings
The port settings on the remote device, such as baud rate and
parity, are the same as those set in the local device configuration.
16. Confirm that the port settings for the remote port are the
same as the settings for the local, with the exception of
the DTE/DCE setting, which will be the opposite.
17. Click Advanced to configure the Output Power Level
or the SPP Connect Output Select (if remote port is
configured as a DCE device) as in the previous screen.
18. When all selections are specified, click Set Port
Configuration to send settings to the remote device.
19. After viewing the confirmation message, click Next.
20. While in the Save Configuration Settings, click Save to
store the settings. The settings are stored in the unit
until it is reconfigured.
21. Turn off both Wavespeed/S units by sliding the three
position switch to the middle position for two seconds.
22. Place both Wavespeed/S units in the On mode, by
sliding the three position switch back to the left (toward
the power connector).