Specifications

Wavespeed/S Configuration Guide (90000407 Rev. C) – Page 3
Wavespeed/S
The Wavespeed/S provides an easy-to-use wireless data solution for legacy applications providing a serial link (RS-
232) to transfer data between devices or between devices and a host. The serial cable can be replaced with a Blue-
tooth
TM
wireless link that is transparent to the software application. Following initial configuration using a
Windows
®
-based Configuration Wizard, the Wavespeed/S takes on the specified DTE or DCE personality and port
settings, providing a wireless data link.
Operating Modes
Serial Cable Replacement
Two Wavespeed/S units are paired together
in a process known as “bonding.” The two
units then form a wireless link acting like a
serial cable, only without the cable.
SPP Server
A single Wavespeed/S unit can be used in
server mode. In this mode, the device will
make its Serial Port Profile (SPP) available
for connection with any SPP-capable Blue-
tooth device.
Pre-Configuration
Each Wavespeed/S unit has been preconfigured to:
Baud Rate: 57,600
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
If you purchased a single Wavespeed/S, the unit is configured as a DTE device. If you purchased a bundled pair of
Wavespeed/S units, one is configured as a DCE device and the other is configured as a DTE device. If your applica-
tion requires different settings, you may reconfigure the units as described in this guide.