User`s guide

Introduction
19
Simple Network Management Protocol (SNMP):
Configure SNMP through the
web interface
Configuration > System > Simple Network Management Protocol
(SNMP) Settings
102
Enable/disable SNMP service
Configuration > Network > Network Services 74
Enable/disable SNMP alarm
traps
Configuration > Alarms > alarm > Send SNMP trap to following
destination when alarm occurs
97, 98
Use SNMP as primary
configuration interface
Basic network and serial settings configurable through standard and Digi-
specific Management Information Blocks (MIBs).
More advanced settings must be set through the web or command-line user
interfaces, and sending alarms as SNMP traps must be configured through
the web interface, on the pages listed above.
39, 134
System information: assign system-
identifying information to a device
Configuration > System > Device Identity Settings 99
Statistics for Digi devices Administration > System Information 137
Status of Digi devices Management > Serial Ports, Connections, Network Services 145
Wi-Fi (wireless LAN) devices:
Wireless LAN Settings Configuration > Network > WiFi LAN Settings 70
Wireless Security Settings Configuration > Network > WiFi Security Settings 71
Wireless 802.1x Authentication
Settings
Configuration > Network > WiFi 802.1x Settings 73
Feature/task Path to feature in the web interface See page