User`s guide

Digi device administration
162
Administration from the command-line interface
Administrative tasks for Digi devices can also be performed from the command line. Here are
several device-administration tasks and the commands used to perform them. See the Digi Connect
Family Command Reference for more complete command descriptions.
Administrative task Command
Backup/restore a configuration from a
TFTP server on the network
backup
Update firmware boot
Telnet to the Digi device's command line interface using a
telnet application or hyperterm.
If security is enabled for the Digi device, a login prompt is
displayed. The default username is “root” and the default
password is “dbps.” If these defaults do not work, contact the
system administrator who set up the device.
Issue the command:
#> boot load=tftp-server-ip:filename
where tftp-server-ip is the IP address of the TFTP server
that contains the firmware, and filename is the name of
the file to upload.
Reset configuration to factory defaults revert
or
boot action=factory
Display system information and statistics info
Reboot the device boot
Enable/disable network services set service