User`s guide

Digi device administration
158
For Digi Connect ME and Digi Connect Wi-ME, short pin 20 (the /init pin) to ground
during boot up to restore the module to factory defaults. Note that shorting pin 14
simply reboots the unit but does not restore the configuration.
4 After a few seconds you may see a 1-1-1 blink once on some devices.
5 Wait until you see the Status LED blink a 1-5-1 pattern, then release the reset button.
6 Wait for the device to boot up. At this time, the configuration is returned to factory defaults.
7 Now, if desired, power off the device, though this is not necessary. Powering off the device
before releasing the button guarantees the configuration will NOT be reverted. Powering off
the device just after releasing the button will result in an unknown configuration, possibly
having some or all settings reverted to defaults.