User`s guide

Configure Digi devices
132
Here are some examples of commands used to configure Digi device. See the Introduction of the
Digi Connect Family Command Reference for a complete list of features and tasks that can be
configured and performed from the command line.
To configure: Use this command:
alarms set alarms
autoconnection behaviors for serial port
connections
set autoconnect
Ethernet communications parameters set ethernet
IP forwarding set forward
GPIO pins set gpio
group attributes: create or establish group
attributes, update or remove groups or group
attributes
set group
host name set host
modem emulation set pmodem
network options set network
network services set service
Point-to-Point (PPP) outbound connections set pppoutbound
port buffering set buffer
port profile for a serial port set profiles
remote management settings
set mgmtconnection
set mgmtglobal
set mgmtnetwork
system-identifying information set system
serial port options--general set serial
serial TCP and serial UDP set tcpserial and set udpserial
RealPort configuration options set realport
RTS toggle set rtstoggle
SNMP set snmp