User`s guide

Configure Digi devices
125
8 Use the set wlan command to configure wireless network settings. This command is
described in the Digi Connect Family Command Reference, available for download from the
Digi Support site and also on the Software and Documentation CD for command
descriptions.
9 After configuring the Digi Connect Wi-SP parameters to function within your network,
disconnect the power supply and the serial cable from the Digi Connect Wi-SP.
10 Reset the DIP switch settings according to serial device requirements (EIA-232/422/485).
11 Connect the antenna and the power supply to the Digi Connect Wi-SP.
12 Start the Digi Device Setup Wizard to discover and the configure the Digi Connect Wi-SP
for your network.
Note See also Digi support site at http://www.digi.com/support/ for additional command
resources.
DB-9
Pinouts
1
2
3
4
5
6
7
8
9
Shell
DCD
RxD
TxD
DTR
GND
DSR
RTS
CTS
RI
GND
CTS-
RxD+
TxD+
RTS-
GND
RxD-
RTS+
CTS+
TxD-
Not Used
RxD+
TxD+
Not Used
GND
RxD-
Not Used
Not Used
TxD-
***
Up/On
Down/Off
EIA-232
EIA-422/485
Full-Duplex
EIA-485
Half-Duplex
Switch
Settings
*If switch 4 is up, termination resistor connected
If down, termination resistor not connected.
*
*
DB-9
Pinouts
1
2
3
4
5
6
7
8
9
Shell
DCD
RxD
TxD
DTR
GND
DSR
RTS
CTS
RI
GND
CTS-
RxD+
TxD+
RTS-
GND
RxD-
RTS+
CTS+
TxD-
Not Used
RxD+
TxD+
Not Used
GND
RxD-
Not Used
Not Used
TxD-
***
Up/On
Down/Off
EIA-232
EIA-422/485
Full-Duplex
EIA-485
Half-Duplex
Switch
Settings
*If switch 4 is up, termination resistor connected
If down, termination resistor not connected.
*
*