User guide

Quick Reference for Configuring Features
Chapter 1 Command Line Configuration Tasks 9
Quick Reference for Configuring Features
The following table shows common features that can be configured, the
Digi devices in which the features are supported, the commands used to
configure each feature, and where to find more information in this chapter.
Feature/Task
Digi Devices supported
in
Commands, discussion, examples
Autoconnection All • "Configure Autoconnection" on page 23
• "set ports" on page 169
• "set user" on page 230
Configuration management:
• Backup/Restore
configuration
All • "cpconf" on page 58
• Upgrade firmware All "Upgrade Firmware" on page 45
• Copy configuration to and
from a remote host
All • "Copy the Configuration to and from a
Remote Host (Backup/Restore)" on page
45
• "cpconf" on page 58
• Reset configuration to
defaults
All • "Reset the Configuration to Defaults" on
page 45
• "revert" on page 79
or:
• "boot" on page 51 (boot action=factory)
Domain Name Server (DNS) All • "Configure Domain Name System
(DNS)" on page 32
• "set config" on page 97
• "set host" on page 124
Embedded Modem PortServer TS M MEI Family • "Configure Embedded Modem" on page
44
• "set embmodem" on page 108
• "set ports" on page 169 (set ports - dev
option, where dev=min, mout, or mio)