User guide

reconnect
76 Chapter 2 Command Descriptions
reconnect
Device support This command is supported in all devices.
Purpose Reestablishes a previously established connection. This command applies
only to sessions that have been backed-out of, but not closed.
Required
permissions
Anyone can use this command.
Syntax reconnect [{serial port|p=serial port|s=session}]
Options serial port
The serial port to which this command applies.
p=serial port | s=session
The serial port or session to which this command applies.
Example Reconnect to the last port used
#> reconnect
See also • "connect" on page 56 for information on establishing a connection on a
selected port.
• "close" on page 54 for information on ending a connection.
• "exit" on page 62.
• "kill" on page 66.
• "quit" on page 75.
• "mode" on page 67.
• "rlogin" on page 83.
• "status" on page 254 for information on gathering status on current
connections.
• "send" on page 85.
• "telnet" on page 255.
• "who" on page 261.