User guide

boot
Chapter 2 Command Descriptions 53
Examples Reload firmware and reset configuration to defaults
#> boot action=factory
Reset all-but the network-related parts of the configuration to defaults
This example does not apply to PortServer TS 8/16.
#> boot action=eewrite
Reboot device and use current firmware and configuration
#> boot action=reset
Load firmware using a boot host
The command loads the firmware stored on the host into flash ROM. A
reboot is required to use the new firmware.
#> boot load=198.150.150.10:os-1
See also • "cpconf" on page 58 for information on saving the current configuration
to a host prior to restoring the configuration to defaults.
• "revert" on page 79 for information on restoring configuration defaults to
the latest configuration stored in NVRAM.