User guide

Configure Power Over Serial Ports
Chapter 1 Command Line Configuration Tasks 43
Configure Power Over Serial Ports
Power over serial ports is only available for the PortServer TS P MEI
Family. Power over serial ports is a hardware feature. Enabling this feature
involves changing a jumper inside the device. See the Digi One and
PortServer TS Family User Guide’s chapter on power over ports for more
details.
Reset the Circuit Breaker
From the command line, the only power-related task you can perform is to
reset the circuit breaker.
1. Display the status of the circuit breaker by entering:
#> display circuitbreaker
or
#> set config print
2. Reset the circuit breaker by entering:
#> set configuration circuitbreaker=reset
For more information, see "display" on page 59, and "set config" on page
97.
Configure User Attributes
Although not required, a Digi device is often configured to accommodate
requirements of particular users. Typical configurable user attributes
include whether the user is required to supply a password; autoconnection
attributes, such as the system to which the user should be automatically
connected at login; the interface the device presents the user, such as a
menu or command line; and whether the user has access to outbound
ports.
User attributes are configured by the following commands:
To: Use This Command:
Set common user-related features set user
Common user-related features are
described in "Common Configurable
User Features" on page 44.
Assign a password to a user newpass
Configure a menu to be automatically displayed for a user set user defaultaccess=menu option
Automatically connect a user set user - autoconnect, autohost,
autoport, autoservice options
Defines the number of outbound ports a user connected over the
LAN can access at one time.
set user - maxsessions option
Remove a user from the user table remove
Use a RADIUS server to set user attributes set radius