User guide

Configure Security Features
40 Chapter 1 Command Line Configuration Tasks
RADIUS Accounting Attributes (RFC 2139)
The following RADIUS accounting attributes are supported in the Digi
device server.
Issue User Passwords
To establish passwords for users, and issue them to users, use the
following commands:
• “set user” with the “password” option to require a password of a user.
See "set user" on page 230.
• “newpass” to create or change a user’s password. See "newpass" on
page 69.
This procedure assumes that you have signed on as “root” and already
used the “set user” command to configure the user to whom you will be
issuing a password.
1. Issue a “newpass” command that identifies the user (on the “name”
option) to whom this password will be issued.
2. When the system prompts you for a new password, type in the
password and then press Enter.
3. When the system prompts you to enter the new password again, type it
in and then press Enter.
# Attribute # Attribute
0-1 User-Name 0-1 Login-TCP-Port
0 User-Password 0-1 Session-Timeout
0 CHAP-Password 0-1 Idle-Timeout
0-1 NAS-IP-Address 1 Acct-Status-Type
0-1 NAS-Port 0-1 Acct-Delay-Time
0-1 Service-Type 0-1 Acct-Input-Octets
0-1 Framed-Protocol 0-1 Acct-Output-Octets
0-1 Framed-IP-Address 1 Acct-Session-Id
0-1 Framed-IP-Netmask 0-1 Acct-Authentic
0-1 Framed-Routing 0-1 Acct-Session-Time
0+ Filter-Id 0-1 Acct-Input-Packets
0-1 Framed-MTU 0-1 Acct-Output-Packets
0+ Framed-Compression 0-1 Acct-Terminate-Cause
0+ Login-IP-Host 0-1 Port-Limit
0-1 Login Service