User guide

set wlan
Chapter 2 Command Descriptions 245
auto_ssid={on|off}
Specifies whether the wireless device automatically detects available Set
Service Identifiers (SSIDs) or uses a configured SSID.
on
The wireless device automatically detects available SSIDs in its
neighborhood, and arbitrarily selects an SSID. If the arbitrarily chosen
SSID is using encryption that does not match the current encryption
mode and encryption key, the device will be unable to associate with
an access point.
off
The wireless device will use the configured SSID. Setting
“auto_ssid=off” is not allowed if SSID is not set to some value other
than “”.
The default is "on."
country_code={United_States|other_country_code_string}
The country code for the device’s radio. The default is United States.
Enter “set wlan ?” at the command line to get the list of country codes
supported by the firmware release in your device.
density={low|medium|high}
The number of access points in the vicinity.
low
One wireless access point is in the vicinity.
medium
Two wireless access points are in the vicinity.
high
Three wireless access points are in the vicinity.
The default is "low."
diversity={primary|secondary|tx_pri_rx_div}
The antenna choice for transmit and receive.
primary
Use the primary antenna for transmit and receive.
secondary
Use the secondary antenna for transmit and receive.
tx_pri_rx_div
Use the primary antenna for transmit and both antennae for receive.
The default is "tx_pri_rx_div."