User guide

set user
242 Chapter 2 Command Descriptions
Examples Display entire user table
#> set user
Display a range of entries in the user table
#> set user range=2-7
Display a single user
#> set user ra=1
Configure an autoconnect user
#> set user name=user4 autoconnect=on autohost=199.193.150.10 autoport=23
defaultaccess=autoconnect
Configure an inbound PPP user
#> set user name=pppin protocol=ppp defaultaccess=netservice netservice=on
#> set user name=pppin ippaddr=ippool localipaddr=192.168.3.4
Configure an outbound PPP user
#> set user name=pppout protocol=ppp papid=pppout pappasswd
#> set user name=pppout device=genmdm localipaddr=0.0.0.0 outgoing=on
n1=4452624
See also • "remove" on page 77 to remove entries from the user table.
• "revert" on page 79. The “revert users” option reverts the “set user”
configuration.