User guide

set user
Chapter 2 Command Descriptions 241
range=range
Identifies an entry or range of entries in the user table to display or
remove.
rloginesc=char
A different escape character than the ~ (tilde) character. This character
is used for disconnecting from the remote host.
rmkey={on|off}
Enables or disables the SSH2 public key defined on the "loadkey" option.
on
Enables the SSH2 public key defined on the "loadkey" option.
off
Disables the SSH2 public key defined on the "loadkey" option.
The default is "on."
rmtbusydly=seconds
The number of seconds that device server delays before reattempting a
connection to a remote system that was previously inaccessible. The
range is 0 to an unlimited number of seconds. The default is 0, which
means no delay.
sessiontimeout=seconds
The maximum time in seconds that a user may be connected. The range
is 0 to an unlimited number of seconds. The default is 0, which means
that there is no limit.
sshbreak=string
The Secure Shell (SSH) escape character or string for this user.
telnetesc=character
The Telnet escape character for this user. Use this option to define a
character to escape (shell-out) of a Telnet session without killing the
session. The default is ^] (Ctrl and right bracket).
vjslots=number
The number of slots used for Van Jacobsen header compression. The
number of slots you configure should correspond to the expected
maximum number of simultaneous connections using Van Jacobson
header compression on this WAN interface. To avoid excessive
processor usage, configure only the number you will need.
The default is 16 and the range is 4 through 255.