User guide

set udpserial
Chapter 2 Command Descriptions 227
set udpserial
Device support This command is supported in all devices.
Purpose Configures operating options for serial over User Datagram Protocol (UDP)
communication, and displays current serial over UDP communication
options.
Required
permissions
The root user can configure serial over UDP options. Normal users can
display serial over UDP options.
Syntax Configure serial over UDP communication options
set udpserial range=ports
[closetime=0-66635 milliseconds]
[delimiters=string]
[overflowpolicy={forward|flush}]
[rmax=max]
[rtime=time]
[stripdelimiters={on|off}]
Display current serial over UDP communication options
set udpserial
Options range=ports
The serial port or serial ports to which this command applies. Enter this
information in any of the following ways:
port=1
port=1-2
port=1,2
port=1,2-4
closetime=0-66635 milliseconds
The time the serial port will remain in an idle state for use by serial over
UDP communication before the port can be closed and made available.
This option is helpful when a serial port is used for several purposes.
Unlike TCP serial, UDP serial does not automatically detect when the
other side has completed the session. Setting this “closetime” option
means that the serial port will not remain in an idle state waiting to
continue serial over UDP communications indefinitely.