User guide

set terms
220 Chapter 2 Command Descriptions
range=range
The range of term table entries to display or remove.
Examples Display entire term table
#> set terms
Display a range of entries in the term table
#> set terms range=4-6
Configure a terminal type
#> set terms termtype=Jet npages=4 clrseq=^! swtseq=1^] swtseq=2^[swtseq=3^}
swtseq=4^{
See also • "remove" on page 77 to remove entries from the terms table.
• "revert" on page 79. The “revert terms” option reverts the “set terms”
configuration.