User guide

set route
186 Chapter 2 Command Descriptions
Examples Display entire route table
#> set route
Display a range of route table entries
#> set route range=3-5
Remove an entry from the route table
#> set route rmroute=on range=2
Configure a route over a WAN connection
#> set route net=199.150.144.8 mask=255.255.255.0 metric=3 wanname=user998
gateway=199.150.100.2
See also • "remove" on page 77 to remove entries from the route table.
• "revert" on page 79. The “revert route” option reverts the “set route”
configuration.
• "set forwarding" on page 120 for information on configuring device
server to use dynamic IP routes maintained by the Routing Information
Protocol (RIP).
• "set user" on page 230 for information on and options for defining PPP
users.