User guide

set powerunit
Chapter 2 Command Descriptions 177
Configure a current threshold
This example configures the current threshold for 15 Amps.
#> set powerunit range=8 alarm1=15
Configure a temperature threshold
This example configures the temperature threshold for 32 degrees C.
#> set powerunit range=8 temp1threshold=32
Configure an ID
In this example, all the devices connected to outlets 1-4 are assigned an
ID, allowing them to be managed as a single unit.
#> set powerunit range=8 outlet=1-4 id=Routers
Configure a group
#> set powerunit range=8 outlet=1-4 group=3
See also • "power" on page 72 for information on managing power-management
devices.
• "remove" on page 77 to remove entries from the powerunit table.
• "revert" on page 79. The “revert powerunit” option reverts the
“set powerconfig” configuration.
• "set snmp" on page 201 to enable the SNMP traps for current and
temperature thresholds being exceeded.
• The Digi One and PortServer TS Family User’s Guide’s chapter on Digi
Remote Power Manager (Digi RPM).