User guide

set pmodem
168 Chapter 2 Command Descriptions
set pmodem
Device support This command is supported in the following devices:
• Digi One SP
• Digi One IA
• All PortServer TS Family products
Purpose Used to configure options for modem emulation over TCP/IP, or display
current modem-emulation settings.
Required
permissions
The root user can configure modem emulation settings. Normal users can
display modem emulation settings.
Syntax Configure modem emulation settings
set pmodem [pmtelnet={on|off}]
[range=range]
[sN=value]
Display modem emulation settings
set pmodem
Options pmtelnet={on|off}
on
Disables the standard Telnet command-line interface for the device.
This means that the device connects to a pmodem pool of serial ports,
and will connect to the first of these serial port that has pmodem
enabled.
Setting this option to “on” means that the device has no command-line
interface. To enable the Telnet command-line interface, you must
reset the device configuration.
off
Enables the standard Telnet command-line interface for the device.
range=range
The range of serial ports to which this command applies.
sN=value
An S-register value, where sN is s-register, ranging from s0 to a
maximum number. S-register values are described in the Modem
Emulation Commands chapter.
See also • "set ports" on page 169
• Chapter 3, "Modem Emulation Commands"