User guide

set ia
128 Chapter 2 Command Descriptions
Configure route entries within destination tables
set ia table=(1..32) route=(1..128)
[active={on|off}]
[connect={active|passive}]
[protaddr=protocol address range]
[type={discard|dns|ip|mapto|nopath|serial}]
[port=(serial port)]
[transport=(tcp|udp)]
[ipaddress=(ip address)]
[ipport=(ip port)]
[filterip=(on|off)]
[replaceip=(on|add|sub|off)]
[splitip=(on|off)]
[splitdivisor=(1-255)]
[splitbase=(0|1)]
[name=(dns name)]
[mapto=(protocol address)]
[messagetimeout=(10-65535 msec)]
[idletimeout=(0=disabled, 1-65535 seconds)]
[reconnecttimeout=(0-65535 seconds)]
[protocol=protocol]
For “protocol,” see "Configure protocol-specific options" on page 128. See
"Options for configuring routes in destination tables" on page 133.
Configure protocol-specific options
These options configure behavior of specific protocols. To use, specify the
“protocol” option, for example, “protocol=modbusrtu,” and one or more
options. Descriptions are on page 136.