User guide

set ia
Chapter 2 Command Descriptions 127
Syntax Configure serial port-connected devices
set ia serial range={port#|port#-port#}
[chartimeout=(3-65535ms)]
[messagetimeout=(10-65535ms)]
[slavetimeout=(10-65535ms)]
[lineturndelay=(0-65535ms)]
[table=(1..32)]
[type={master|slave}]
[protocol=protocol]
For “protocol,” See "Configure protocol-specific options" on page 128. See
“Options for configuring serial port-connected devices” on page 130. To set
the baud rates for the port, see "set line" on page 149. To enable the IA
protocols for this port, see "set ports" on page 169.
Configure network-based masters
This syntax is for configuring network-based message sources other than
encapsulated serial protocols on TCP ports 20xx, 21xx, or Digi RealPort.
set ia master range=(1..32)
[active=(on|off)]
[chartimeout=(3-65535ms)]
[command=(destroy)]
[ipport=(0-65535)]
[type={tcp|udp}]
[table=(1..32)]
[messagetimeout=(10-65535ms)]
[idletimeout=(10-65535sec)]
[permit={all|readonly|rdwrdata}]
[priority={high|medium|low}}
[protocol=protocol]
For “protocol,” see "Configure protocol-specific options" on page 128. See
"Options for configuring network masters – incoming message sources" on
page 131.
Configure destination tables
set ia table=(1..32)
[command={destroy}]
[name=(string)]
[addroute=(route index)]
[removeroute=(route index])
[moveroute=(from_route_index, to_route_index)]
See "Options for configuring destination tables" on page 133.