User guide

set forwarding
122 Chapter 2 Command Descriptions
proxyarp={on|off}
Specifies whether proxy ARP services are enabled. Proxy ARP is a
technique in which a router answers ARP requests intended for another
system. By pretending to be the other system, the router accepts
responsibility for forwarding packets to that system. Use proxy ARP to
route packets to and from serial routes on the same IP subnetwork as the
device server’s Ethernet interface.
on
Provide proxy ARP services.
off
Do not provide proxy ARP services.
The default is "off."
splithorizon={on|off}
Specifies whether the splithorizon option is enabled.
on
The "splithorizon" option is on. When this option is on, learned routes
are not propagated from the interface on which they are learned. Use
this option only if "state=active."
off
The "splithorizon" option is "off."
The default is "on."
save={on|off}
Specifies whether the configuration will be saved.
on
The configuration will be saved.
off
The configuration will not be saved, which means that configuration
changes will be lost the next time the device server re-initializes.
The default is "on."
state={off|passive|active}
The state of routing for the device server.
off
Limits routing to static routes defined in the route table. See "set route"
on page 185.
passive
Configures the Digi device to use the Routing Information Protocol
(RIP) to learn routes but not to propagate them.
active
Configures the device server to use RIP to both learn and propagate
routing information.
The default is "off."