User guide

set flow
118 Chapter 2 Command Descriptions
forcedcd={on|off}
Determines whether the port acts as though DCD were always high. The
primary implications is that autoconnections are launched as soon as the
Digi device completes booting when this option is on and an appropriate
incoming device type (see the "set ports" "dev" option) is defined for the
port. The default is "off."
itoss={on|off}
Used only with software flow control (XON\XOFF) and only if "ixany=on:"
on
The character that resumes output is discarded.
off
The character that resumes output is not discarded.
The default is "off."
ixany={on|off}
Used only with software flow control.
on
Any received character can restart output when output has been
stopped because of software flow control. Specify “on” only when
communicating with devices, such as printers and terminals that use
software flow control (XON\XOFF).
off
Output will resume only when the XON character is received.
The default is "off."
ixoff={on|off}
Determines whether to use input software flow control.
on
Use input software flow control.
off
Do not use input software flow control.
The default is "on."
ixon={on|off}
Determines whether to use output software flow control.
on
Use output software flow control.
off
Do not use output software flow control.
The default is "on."
pre-delay=milliseconds
Specifies the time in milliseconds to wait after the RTS signal is turned on
before sending data. The range is 0 to 5000 milliseconds, and the default
is 0. This option does not apply to PortServer TS 8/16 devices.