User guide

Quick Reference for Configuring Features
Chapter 1 Command Line Configuration Tasks 11
Port sharing
This is an advanced serial-port
setting that allows more than
one client to open a serial port
through RealPort, reverse
Telnet, reverse SSH, or
connect.
All; console menu feature
available on PortServer TS
Family devices only.
• "Configure Port Sharing" on page 24
• To configure port-sharing options:
"set sharing" on page 198
• To display port-sharing options:
"set sharing" on page 198“or "show" on
page 251 (“show sharing” option
• To set up the console menu options, for
displaying current users, disconnecting
other sessions, displaying entries in the
port buffer, or accessing the command
line: "set consmenu" on page 102.
Power Features:
• Power through Integrated
Remote Power Management
(RPM)
PortServer TS Family • "power" on page 72
• "set powerunit" on page 175
• Power Over Ethernet (POE) Digi One IAP
PortServer TS P MEI Family
This is a hardware feature. There are no
configurable software settings for this
feature.
• Power Over Ports/Power
Over Serial
PortServer TS P MEI Family This is a hardware feature. Enabling it
involves changing a jumper inside the
device. See "Configure Power Over Serial
Ports" on page 43
• To display status of circuit breaker:
“display circuitbreaker” (See "display" on
page 59) or “set config print”
• To reset circuitbreaker:
“set config
circuitbreaker=reset” (See "set config"
on page 97)
RealPort All • See also the RealPort Setup Guides for
details on configuring this feature.
• To configure RealPort authentication
options, see "set rpauth" on page 187.
Remote login (rlogin) All • "rlogin" on page 83
• "set rloginoption" on page 184
Revert configuration settings All "revert" on page 79
Feature/Task
Digi Devices supported
in
Commands, discussion, examples