User guide

set config
Chapter 2 Command Descriptions 101
tbreak={std|any|none}
Sets the Telnet break keystroke (tbreak).
Once a Telnet connection is initiated, but before the connection is
established, the connection can be broken by entering a designated
keystroke. This keystroke is determined by these settings.
std
Configures tbreak so only the ^] (control right bracket) keystroke will
break a Telnet connection.
any
Configures tbreak so any keystroke will break a Telnet connection.
none
Configures tbreak so no keystroke will break a Telnet connection.
The default is "std."
tftpboot={yes|no|smart}
(This option does not apply to PortServer TS 8/16)
Specifies booting conditions for the device server.
yes
Always boot from the TFTP host identified on the "boothost" option.
smart
If the device server cannot boot from the TFTP host identified on the
"boothost" option, boot from the device server’s internal flash ROM
instead.
no
Boot the device server from internal flash ROM.
The default is no.
Example Display the network parameter configuration table
#> set config
See also • "revert" on page 79. The “revert config” option reverts the “set config”
configuration.
• The Digi One and PortServer TS Family User’s Guide’s chapter on
latency tuning.