User`s guide

95
This would cause the router to create a warning entry in the event log once 4MB of data
had been transferred. This event could then be used to trigger an email alert, SNMP trap
or SMS alert message.
Stop data from being transmitted after n units
The value in this text box specifies the total amount of data that may be transmitted by
this PPP instance before the link is blocked for further traffic, and the value in the drop-
down list specifies the units which are; KBytes, MBytes, GBytes.
Reset the data limit on the n day of the month
The value in this text box defined the day of the month on which the data limit is reset to
zero.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
ppp n metric 0 - 255 Metric
ppp n aodion
0 – 2
0 = disabled
1 = enabled
2 = On and return
to service
immediately
Enable “Always On” mode of
this interface, On, On and
return to service immediately
ppp n immoos ON, OFF
Put this interface “Out of
Service” when an always-on
connection attempt fails
ppp n aodi_dly 0 – 2147483647
Attempt to reconnect after s
seconds
ppp n aodi_dly2 0 – 2147483647
If an inhibited PPP interface is
connected, attempt to re-
connect after s seconds
ppp n pwr_dly 0 – 2147483647
Wait s seconds after power-up
before activating this interface
ppp n tband 0 - 4
Control when this interface can
connect using Time Band n
ppp n minup 0 – 2147483647
Keep this interface up for at
least s seconds
ppp n maxup 0 – 2147483647
Close this interface after s
seconds
ppp n maxuptime 0 – 2147483647
if it has been up for m minutes
in a day
ppp n timeout 0 – 2147483648
if the link has been idle for s
seconds
ppp n timeout2 0 – 2147483648
Alternative idle timer for static
routes s seconds
ppp n rxtimeout 0 – 2147483648
if the link has not received any
packets for s seconds