User`s guide

86
Entity
Instance
Parameter
Values
Equivalent Web Parameter
ppp 0 cingnb number ending with
ppp 0 msn number with ISDN MSN ending with
ppp 0 sub number
with ISDN sub-address ending
with
ppp 0 ipaddr IP address Local IP Address:
ppp 0 mask Network mask Mask:
ppp 0 ipmin IP address
Assign remote IP addresses from
a.b.c.d to a.b.c.d
ppp 0 iprange 1 - 255
Assign remote IP addresses from
a.b.c.d to a.b.c.d
ppp 0 dnsserver IP address Primary DNS server:
ppp 0 secdns IP address Secondary DNS server:
ppp 0 do_nat 1
Enable NAT on this interface
IP Address:
ppp 0 do_nat 2
Enable NAT on this interface
IP address and Port:
ppp 0 ipsec 1 Enable IPsec on this interface
ppp 0 ipsec 2
Keep Security Associations (SAs)
when this ISDN interface is
disconnected
ppp 0 ipsecent
Default,Ethernet,
PPP
Use interface X, Y for the source IP
address of IPsec packets
ppp 0 ipsecadd number
Use interface X, Y for the source IP
address of IPsec packets
ppp 0 firewall on/off
Enable the firewall on this
interface
Advanced
Configuration - Network > Interfaces > ISDN> ISDN Answering> Advanced
These are the advanced settings for the ISDN interface.
Metric:
This parameter specifies the connected metric of the mobile interface. The default metric of
a connected interface is 1. By allowing the interface to have a higher value (lower priority),
static routes can take preference to interfaces. For normal operation, leave this value
unchanged.
Enable "Always On" mode of this interface
On
This parameter is used to configure the PPP instance so that in the event that it is
disconnected the unit will try to reconnect again after approximately 10 seconds or
dictated by the Configuration - Network > IP Routing/Forwarding > IP Routing >