User`s guide

78
Entity Instance Parameter Values
Equivalent Web
Parameter
apvc 0 scr n
Sustained cell rate
(cells/sec)
apvc 0 mbs n
Maximum burst size
(cells)
Advanced
Configuration – Network > Interfaces > DSL> Advanced
Operational mode
This parameter is used to specify the connection mode for the DSL link. The following options
are available
(default is Multi mode).
Values
Equivalent Web Parameter
Multi-mode
For Annex A models (i.e. PSTN / POTS) this option provides automatic
selection between G.dmt, G.lite and ANSI (in the order listed).
For Annex B models (i.e. ISDN) this option provides automatic selection
between G.dmt (in the order listed)
ANSI Annex A only - attempt to connect in ANSI T1.413 mode
G.dmt Attempt to connect in ITU G.992.1 G.dmt mode
G.lite Annex A only - attempt to connect in ITU G.992.2 G.lite mode
ADSL2 Connect using ADSL2
ADSL2+ Connect using ADSL2+
Load DSL firmware from flash file ‘dspfw.bin’ (if present)
This checkbox enables the use of alternative ADSL driver firmware and should only be
enabled on the advice of the technical support team. This option also requires that an
additional file be loaded onto the router.
Enable watchdog
This checkbox should only be enabled on the advice of the technical support team.
Manage this PVC using ATM OAM cells
Using Alarm indication signal (AIS) cells downstream and Remote defect indication (RDI)
cells upstream, the router can detect faults between the connecting points of the VP/VC and
suspend transfer of ATM cells until the VC fault condition is cleared.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
adsl 0 oper_mode
Multi,ANSI,G.dmt,
G.lite,ADSL2,
ADSL2+
Operational mode
adsl 0 usefwfile ON/OFF
Load DSL firmware from flash
file
adsl 0 watchdog ON/OFF Enable watchdog