User`s guide

69
Enabling this parameter causes the unit to use the IP address of ETH0 (instead of the
current IP address of the mobile interface), as the source address for the auto PING
packets.
Note:
This parameter is useful if you want to send the monitoring pings down a VPN tunnel
where the source IP address needs to match the LAN.
Defer sending pings if IP traffic is being received
When enabled, the timer configured in the “Send n byte pings to IP host a.b.c.d
every h hrs m mins s secs” parameter will be reset if IP data is sent across the mobile
link.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
ppp 1 metric 0 - 256 Metric
ppp 1 hrtbeatip IP address
Send Heartbeat messages to IP
address a.b.c.d every h hrs m
mins s secs
ppp 1 hrtbeatint
0 – 2147483647
(seconds)
Send Heartbeat messages to IP
address a.b.c.d every h hrs m
mins s secs
ppp 1 hbipent Default,PPP,Ethernet
Use interface x,y for the source
IP address
ppp 1 hbipadd number
Use interface x,y for the source
IP address
ppp 1 hbroute on/off
Select transmit interface using
the routing table
ppp 1 hbimsi on/off
Include IMSI information in the
Heartbeat message
ppp 1 hbgps on/off
Include GPS information in the
Heartbeat message
ppp 1 pingsiz number
Send n byte pings to IP host
a.b.c.d every h hrs m mins s
secs
ppp 1 pingip hostname
Send n byte pings to IP host
a.b.c.d every h hrs m mins s
secs
ppp 1 pingint
0 – 2147483647
(seconds)
Send n byte pings to IP host
a.b.c.d every h hrs m mins s
secs
ppp 1 pingint2
0 – 2147483647
(seconds)
Send pings every h hrs m mins
s secs if ping responses are not
being received
ppp 1 pingip2 IP address
Switch to sending pings to IP
host a.b.c.d after n failures