User`s guide

61
By default, the source IP address for an IPSec Eroute will be the IP address of the
interface on which IPSec was enabled. By setting this parameter to either a PPP or
Ethernet interface, the source IP address used by IPSec will match that of the Ethernet or
PPP interface specified.
Enable the firewall on this interface
The Firewall parameter is used to enable or disable the Firewall script processing for the
mobile interface.
Note:
If the firewall is enabled on an interface and with the absence of any firewall rules, the
default action is to block ALL traffic.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
ppp 1 do_nat 1
Enable NAT on this interface
IP Address
ppp 1 do_nat 2
Enable NAT on this interface
IP Address and Port
ppp 1 ipsec 1 Enable IPsec on this interface
ppp 1 ipsec 2
Keep Security Associations (SAs)
when this Mobile interface is
disconnected
ppp 1 ipsecent blank,ETH,PPP
Use interface X, Y for the source
IP address of IPsec packets
x = Interface type
ppp 1 ipsecadd 0 - 255
Use interface X, Y for the source
IP address of IPsec packets
y = interface number
ppp 1 firewall on/off
Enable the firewall on this
interface
SIM Selection
Configuration – Network > Interfaces > Mobile > SIM Selection
This section allows you to launch the Dual SIM wizard for failing over from 1 SIM to another.
Click here to launch the Dual SIM wizard
Click the hyperlink to launch the Dual SIM wizard.
CDMA Provisioning
If the router was not supplied pre-provisioned, obtain the following details from the Service
Provider:
a 15 digit IMSI (International Mobile Subscriber Identity)
an NAI (Network Access Identifier)