User`s guide

60
SIM 2 (PPP 1)
Entity
Instance
Parameter
Values
Equivalent Web Parameter
modemcc 0 Apn_2 Free text field Service Plan / APN:
modemcc 0 Usebuapn_2 on/off Checkbox (Use Backup APN)
modemcc 0 Buapn_2 Free text field Use backup APN
modemcc 0 Pin_2 SIM PIN number SIM PIN:/Confirm SIM PIN
ppp 1 username Free text field Username:
ppp 1 password Free text field Password:/Confirm Password
Mobile Connection Settings
Re-establish connection when no data is received for a period of time.
This checkbox opens to show the following parameters:-
Inactivity Timeout: h hrs m mins s seconds
This parameter specifies the amount of time the unit will wait without receiving any PPP
packets before disconnecting. An inactivity timeout reset with each received PPP packet.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
ppp 1 rxtimeout
0 – 86400
(seconds)
Re-establish connection when no data is
received for a period of time.
Inactivity Timeout: h hrs m mins s
seconds
Mobile Network Settings
Enable NAT on this interface
This parameter is used to enable or disable IP Network Address Translation (NAT) on the
mobile interface.
This checkbox opens to show the following options:-
IP Address:
Enable standard Network Address Translation (NAT).
IP address and Port:
Enable Network Address and Port Translation (NAPT).
Enable IPsec on this interface
This parameter is used to enable or disable IPSec processing on the mobile interface. If
enabled, packets sent or received on this interface must pass through the IPSec code before
being transmitted. IPSec may drop the packet, pass it unchanged, or encrypt and
encapsulate within an IPSec packet.
This checkbox opens to show the following parameters:-
Keep Security Associations (SAs) when this Mobile interface is disconnected
This checkbox will configure the router to keep any existing IKE and IPsec associations
should the link drop. This is usually applied on head-end routers with fixed IP addresses.
Use interface X, Y for the source IP address of IPsec packets