User`s guide

54
Hide SSID
When enabled, the SSID will not be included in the beacon messages transmitted by the Wi-
Fi interface when in Access Point mode. This means that Wi-Fi clients will not be able to
auto-detect the Access Point.
Isolation
When enabled, connected Wi-Fi clients will not be able to communicate with other Wi-Fi
clients or Ethernet hosts connected to this AP.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
wifinode 0 enabled on, off Enable this Wi-Fi interface
wifinode 0 descr String Description
wifinode 0 ssid
String up to 32
characters
SSID
wifinode 0 mode ap, client, rogue Mode
wifinode o bridge_inst 0 - 3
This Wi-Fi interface is a member
of Bridge instance n and
therefore bridged to the following
interfaces
eth n bridge_inst 0 – 3 Interface
eth n wificli On/Off
Link this Wi-Fi client interface
with Ethernet n
eth n wificli_add Integer
Link this Wi-Fi client interface
with Ethernet n
wifinode 0 broadcastssid On/ Off Hide SSID
wifinode 0 isolation On/Off Enable station isolation
wifinode 0 identity
EAP authentication server
identity
wifinode 0 sslcli_add
SSL
client configuration
wifinode 0 eap_tls On/Off
wifinode 0 eap_peap On/Off
Wi-Fi Security
Configuration – Network> Interfaces> Wi-Fi> Wi-Fi n> Wi-Fi Security
This section is used to configure the security settings for the Wi-Fi interface.
If using multiple Wi-Fi interfaces at the same time then the interfaces will need to use the
same security settings (except for the pre-shared key (PSK)). The only alternative is that
the Wi-Fi is be used with no security.
Use the following security on this Wi-Fi interface
Selects the security that is used on this Wi-Fi interface. The options are: