User`s guide
500
System
The System hierarchy consists of the following:
at\smib=mib-2.system.sysdescr
This variable shows the software version information (equivalent to what is shown on the
βati5β CLI command output).
mib-2.system.sysdescr =
Software Build Ver5121. Jan 31 2011 12:26:04 9W
at\smib=mib-2.system.sysobjectid
The authoritative identification of the network management subsystem. The Digi does not
support outputting OID variables. Instead, β
oidβ is output.
mib-2.system.sysobjectid = oid
at\smib=mib-2.system.sysuptime
The time the unit has been running in 10msec units (hundredths of a second).
mib-2.system.sysuptime = 1806718
The above example shows that the unit has been running for 5 hours, 1 minute and 7.18
seconds.
at\smib=mib-2.system.syscontact
A description of the contact person for the unit. For the Digi, this is always a zero-length
string.
at\smib=mib-2.system.sysname
The name of the unit (the name set in the Router Identity parameter on the
Configuration - System > Device Identity page).
mib-2.system.sysname = digi.router
at\smib=mib-2.system.syslocation
The physical location of the unit. For the Digi, this is always a zero-length string.
at\smib=mib-2.system.sysservices
This variable displays a value that represents the set of services the unit provides. For each
OSI layer the unit provides services for, 2(L-1) is added to the value, where L is the layer.
The layers are shown below:
Layer
Functionality
1 Physical
2 Data Link
3 Network
4 Transport
5 Session
6 Presentation
7 Application