User`s guide

403
IP Addresses
This parameter is used to filter out IP packets with particular source or destination IP
addresses. The format of this parameter is a comma-separated list of IP addresses. For
example, you may wish to exclude the capture of traffic from IP hosts 10.1.2.3 and
10.2.2.2. This can be done by entering “10.1.2.3,10.2.2.2” for this parameter.
Conversely, you may wish to only capture traffic to and from particular IP hosts. To do
this, use a tilde (~) symbol before the list of IP addresses. For example, to only capture
packets to and from IP host 192.168.47.1, enter “~192.168.47.1” for this parameter.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
ana 0 anon on, off Enable Analyser
ana 0 maxdata 16 - 2000 Maximum packet capture size
ana 0 logsize 3 -180 Log Size
ana 0 l1on on, off Protocol Layers / Layer 1
ana 0 l2on on, off Protocol Layers / Layer 2
ana 0 l3on on, off Protocol Layers / Layer 3
ana 0 xoton on, off Protocol Layers / XOT
ana 0 ikeon on, off Enable IKE debug
ana 0 qmion on, off Enable QMI trace
ana 0 snaipon on, off Enable SNAIP trace
ana 0 lapdon
0 – 7
See below
ISDN Sources
ana 0 lapbon
0 – 7
See below
LAPB Links
ana 0 asyon
Bitmap
See below
Serial Interfaces
ana 0 syon
Bitmap
See below
Raw SYNC Sources
ana 0 discardson on, off IP Options / Trace discarded packets
ana 0 loopon on, off IP Options / Trace loopback packets
ana 0 ipfilt
Comma
separated list
IP Packet Filters / TCP/UDP Ports
ana 0 ipprotfilt
Comma
separated list
IP Packet Filters / IP Protocols
ana 0 ipaddfilt
Comma
separated list
IP Packet Filters / IP Addresses
ana 0 discportfilt
Comma
separated list
Discarded IP Packet Filters / TCP/UDP
Ports
ana 0 discprotofilt
Comma Discarded IP Packet Filters / IP