User`s guide

40
Entity
Instance
Parameter
Values
Equivalent Web Parameter
address of IPsec packets
x = Interface type
eth n ipsecadd 0 - 255
Use interface x,y for the source IP
address of IPsec packets
y = interface number
eth n firewall 0,1 Enable the firewall on this interface
eth n nocfg 0,1,2,3
Remote management access
0 = No restrictions
1 = Disable management
2 = Disable return RST
3 = Disable management
and return RST
eth n mhome 0 - 255
Multihome additional consecutive
addresses
eth n arpnetonly
0, 1
(default: OFF)
Respond to ARP requests only if the
requestor is of this network
eth n igmp 0,1 Enable IGMP on this interface
eth n bridge 0,1 Enable Bridge on this interface
eth n heartbeatip IP address
Send Heartbeat messages to IP
address a.b.c.d every h hrs m mins
s seconds
eth n hrtbeatint 0 - 86400
Send Heartbeat messages to IP
address a.b.c.d every h hrs m mins
s seconds
This CLI value is entered in seconds
only.
eth n hbipent blank,ETH,PPP
Use interface x,y for the source IP
address
x = Interface type
eth n hbipadd 0 - 255
Use interface x,y for the source IP
address
y = interface number
eth n hbroute 0,1
Select the transmit interface using
the routing table
eth n hbimsi 0,1
Include IMSI information in the
Heartbeat message
eth n hbgps 0,1
Include GPS information in the
Heartbeat message
eth n pingsiz value in bytes
Send n byte pings to IP host a.b.c.d
every h hrs m mins s seconds
eth n pingip IP address
Send n byte pings to IP host a.b.c.d
every h hrs m mins s seconds