User`s guide

383
Route OOS Count
The number of Route “Out Of Service” messages sent by the firewall to the routing code.
These messages put routes out of service for a period of time and are sent when enough
failed PPP transactions have occurred.
Related CLI Commands
Command
Instance
Parameter
Equivalent Web Parameter
ppp n status
Displays the current status of PPP interface
n.
at\mibs=ppp.n.stats
n/a n/a Displays the statistics for PPP interface n.
at\mibclr=ppp.n.stats
n/a n/a Clears the statistics for PPP interface n.
IP Routing Table
Management-Network Status> IP Routing Table
This page displays the IPv4 routing table.
Destination
The destination IP network of the route. The destination needs to match the destination IP
address of an IP packet for the route to be used.
For default routes, the destination IP network is always 0.0.0.0/0. Default routes are used
when no other route matches the destination IP address of an IP packet.
Src Addr
When source address routing is being used, the src addr needs to match the source IP
address of an IP packet for the route to be used.
Gateway
The IP address of the next router to which the IP packet will be routed to in order to reach
the destination network.
On PPP and TUN interfaces and ETH interfaces that have the gateway configured, this
parameter can be blank.
Metric
The route metric defines the “cost” of the route. If CIDR routing is enabled and there are
two routes to the same destination, the route with the lower metric is used.
Protocol
The protocol that created the route. It can be one of the following