User`s guide

353
If required, due to the TACACS+ server being accessed via a VPN tunnel, an alternative
source interface and instance may be selected here. Select the required interface from the
drop-down list and enter the instance of that interface into the adjacent text box. The
available interface options are
• Auto
• PPP
• Ethernet.
Response Timeout s seconds
Text box
Stop the negotiation if there is no activity for s seconds
The number in this text box specifies the amount of time (in seconds) before an inactive
socket is closed.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
tacplus 0 ip_ent
Blank,ETH,PPP
Blank = Auto
Use source IP Address x,y
tacplus 0 ip_add 0 - 2147483647 Use source IP Address x,y
tacplus 0 respto
0 – 2147483647
Default = 30
Response Timeout s seconds
tacplus 0 inact
0 – 2147483647
Default = 30
Stop the negotiation if there is
no activity for s seconds
Command Filters
Configuration – Security> Command Filters
When this feature is enabled, commands will not reach the router’s command interpreter
unless they are defined in the Command Filters table. Terminal devices may send
commands that the router will not necessarily understand but that require a basic “OK” or
“ERROR” response.
With command filtering turned on, any command entered will be responded to with a
MODEM-like “OK” or “ERROR” response (depending on settings below) unless the command
is found in the Command Filters table. The command filter uses wild-character matching so
that command filters such as “cmd*” are permitted which would allow all “cmd 0 ...”
commands to be executed. Note that the command mapping table is checked first and the
command filter table is only checked if there was not a match in the command matching
table.
For more information on command filtering there is an application note “Command Line
Response Manipulation” which is available on the Digi web site (www.digi.com).
The table is generated by typing the desired command into the text box and clicking the
“Add” button. Once a command has been entered into the table, it can be removed by
clicking the “Delete” button that appears on the right hand side.
Command
This text box contains the command to filter.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter