User`s guide

352
Enable local authentication if there is no response from the server(s)
When checked, this checkbox will allow local authentication if TACACS+ authentication fails.
Enable TACACS+ Authentication
When checked, this checkbox enables authentication. When authentication is enabled, user
authentication takes place on the TACACS+ server. When disabled, user authentication takes place
locally on the router.
Enable TACACS+ Authorisation
When checked, this checkbox enables authorisation which means that authorisation of the application
takes place and authorisation of application-related commands also takes place.
Enable TACACS+ Accounting
When checked, this checkbox enables accounting. When accounting is enabled, accounting messages
are sent at the start and end of application sessions (where applicable) and update messages are also
sent from command sessions when commands are denied locally or after they are executed.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
tacplus 0 svr
Up to 64
characters for
hostname or
valid IP address
a.b.c.d
Hostname or IP address of
server
tacplus 0 port
0 – 2147483647
Default 49
Port
tacplus 0 key
Up to 20
characters
Server Key
tacplus 0 svr2
Up to 64
characters or
valid IP address
a.b.c.d
Hostname or IP address of
server
tacplus 0 key2
Up to 20
characters
Server Key
tacplus 0 localauth OFF,ON
Enable local authentication if
there is no response from the
server(s)
tacplus 0 authent OFF,ON Enable TACACS+ Authentication
tacplus 0 author OFF,ON Enable TACACS+ Authorisation
tacplus 0 acct OFF,ON Enable TACACS+ Accounting
tacplus 0 debug OFF,ON n/a
tacplus 0 tacacspageauth OFF,ON n/a
Advanced
Configuration – Security> TACACS+> Advanced
The parameters described in this section should not normally need to be adjusted.
Use source IP Address x,y