User`s guide

328
<Command>
This parameter is the CLI command to run on start-up. In the above example, this field
would be set to the string “bas sample.bas”.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
cmd n autocmd
Valid CLI
command
Autorun Commands
Web / Command Line Interface
The router may be configured using several different methods. This section describes how to
configure the web GUI and CLI (Command Line Interface) options.
Automatically log user out if idle for h hours m minutes s seconds
In order to limit the probability of unauthorised users gaining access to the router, login
timeouts are applied. These cause an existing connection to be closed after a predefined
period. The default is 20 minutes.
For users connected on the local Async port
Use access level None, Low, Med, High, Super
For security purposes, logging into the unit is controlled by a user access level. This
parameter controls the access level that applies when logging in via the local
asynchronous serial port.
Automatically log user out Never / If idle for h hrs m mins s secs
These radio buttons control how long the local port allows access before terminating the
connection and requiring the user to log in again. Selecting the “Never” buttons allows
permanent access to the router via the local asynchronous serial port. If, for security
reasons, it is required that the access should be limited, the appropriate time period can
be entered into the text entry boxes.
Disable Remote command echo for Telnet sessions
This checkbox enables/disables command echo for remote access. This applies to telnet and
TRANSIP sessions.
CLI Pre-Login Banner
The router offers the facility to display a banner before any login information is requested.
The parameter specifies the name of a file that is stored in the flash filing system and
contains the text to be displayed before the request for the username and password. This
can be useful for displaying a standard welcome message or any site-specific user
instructions.
CLI Post-Login Banner
Once the user has successfully logged on to the router, a second message may be displayed
- this parameter specifies the name of a file containing the text to display. As above, the file
may contain site-specific instructions to be carried out once the user has logged in.
Allow CLI access from X.25 address n
This parameter enables/disables logging into the router over an X.25 connection. The
paramtern n must be a valid X.25 NUA (Network User Address).
With TRANSIP, use access level None, Low, Med, High, Super
This drop-down selection box controls the security access level when using TRANSIP to
access the router.
Relevant CLI Parameters