User`s guide

280
This parameter specifies the length of time in seconds after which the PAD will terminate an
X.25 call if there has been no data transmission.
Disconnect the layer 2 call if there is no layer 3 call in progress for x seconds
This parameter specifies the length of time in seconds after which the unit will disconnect a
layer 2 link if there are no layer 3 calls in progress. For LAPB sessions this will also
terminate the ISDN call.
Create an event when the following data is on the PAD
This parameter specifies a string, which if it appears in the received data causes a “Data
Trigger” (47) event to be generated and recorded in the event log.
Create an event when there has been no activity on the PAD for x seconds
This specifies the time in seconds in which if there is no activity on the PAD an event in the
event log will be posted. This can be used to trigger email exceptions.
Related CLI Commands
Entity Instance Parameter Values
Equivalent Web
Parameter
pad n l2iface lapb, lapd, TCP, SSL Use PAD over interface
pad n l2nb
0 – 255 (instance of LAPB
or LAPD)
Use PAD over interface
pad n ip_stream
0 = off (for XoT), 1 = TCP,
2 = UDP
Use PAD over interface
pad n defpak
16,32,64,128,256,512 or
1024
Default X.25 packet size
pad n ansnua text (valid NUA)
Answer incoming calls
from NUA
pad n anscug text (valid CUG)
Only answer calls with
CUG
pad n amacro text
Use X.25 Call Macro
macroname to an ATD
command
pad n cingnua text (valid NUA) Use NUA
pad n lcn 1 - 4095 LCN
pad n lcnup 1 = up, 0 = down LCN Direction
pad n nuaimode
0 = NUI and NUA, 1 = NUA
only, 2 = NUI only
NUI/NUA selection
pad n dorest 1 = enabled, 0 = disabled
Enable X.25 Restart
Packets
pad n restdel 0 - 60000 (ms) Restart delay
pad n IPaddr text Remote IP address
pad n buipaddr text
Remote IP Address when
using the backup interface
pad n ip_port 0 - 65535 IP Stream port