User`s guide

Configuring and Testing W-WAN Models

Refer to the Configuration - Network > Interfaces > Mobile section of this guide to

configure your router for the correct APN and PIN code (if any). You can now power up your

unit and test connection to the wireless network. If you have correctly configured

everything, the W-WAN SIM indicator on the front panel should illuminate green to show

that a W-WAN enabled SIM card is present. The unit will now attempt to log on to the

specified mobile network and if it is able to do so, the W-WAN NET indicator will illuminate

steady. Data passing to and from the network will be reflected by the status of the DAT

indicator, which will flash green. If you are unable to connect to the network, go to the

Management - Network Status > Interfaces > Mobile web page and press the Refresh

button. The page should appear similar to the following:

Note:

The signal strength is shown in “negative dB”, which means that the stronger the signal, the

lower the number. As a guide -51dB would be a very strong signal, only normally obtained

very close to a cell site. -115dB represents no signal. If your unit reports -115dB try

reorienting the antenna or consider adding an external antenna.