User`s guide

255
Include MAC Exclusivity Capability
On or Off. Set this parameter to “On” in order to include the MAC exclusivity value in the
capabilities exchange message.
MAC Exclusivity Value
See above.
Ignore unsolicited response frames
When this parameter is enabled, the unit will ignore unsolicited response frames.
Wait for Contact before progressing to CONNECT PENDING state
During the DLSw negotiation phase and when XID messages are being exchanged this
parameter controls which end sends the “CONTACT” message. Normally this would be off in
which case this unit would send the “CONTACT” message, but if this parameter is set we
would not send this message but instead wait for it to be sent to us before progressing in
the DLSw state machine.
Make immediate connection attempts before backing off
This parameter defines the number of successive connection attempts before backing off for
the number of seconds (default 30) defined in the “Backoff for x seconds” parameter. This
backoff might be necessary in the case where a servers is behind a firewalls that detects too
many successive connection attempts in a certain time frame.
Backoff for x seconds before attempting to connect again
When backing off because of too many failed consecutive connection attempts this
parameter defines the time in seconds that we should remain idle for before attempting
another connection.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
snaip x l1iface
ISDN, Port,
SharedPort
Send SNAIP traffic over interface
snaip x l1nb
0 – 255 (Select LAPB,
Port or SharePort
instance)
Send SNAIP traffic over interface
snaip x protocol
LAPB, SNA, RAW,
RAW_NOHDR
Use protocol
snaip x ans 1 = enabled, 0 = disabled Allow this unit to answer calls
snaip x msn text
Only accept calls with MSN ending
with
snaip x sub text
Only accept calls with sub-address
ending with
snaip x autocontact
1 = enabled, 0 = disabled
Assume station exists (Do not
send TEST frames)
snaip x dcd_toggle 1 = enabled, 0 = disabled
Toggle DCD output each time the
DLSw protocol enters the
DISCONNECTED state
snaip x l1oos 1 = enabled, 0 = disabled
Sync port should not send or
receive data when WAN link is
down