User`s guide

223
This allows the OpenVPN instance to use an extra level of security by having a TLS
password configured.
Use file for TLS Auth Key
Select this when TLS Authoorization key is a file.
TLS password filename
Select the filename of the OpenVPN TLS authentication key from this drop-down list.
TLS Auth Key direction
Select the authentication key direction for usage of different tx and rx authentication key
files. This is enabled when TLS Authoorization key is a file.
User Name
This is the user name sent to remote peer.
Password
This is the password sent to remote peer
Require remote peer to supply Username and Password
This Boolean field is turned ON if the remote is required to send username/password. If it is
ON and the remote peer fails to send username/password, the negotiation will fail. If it is
turned OFF, the username/password from the remote peer is ignored.
Push IP address #1/#2/#3
When configured as an OpenVPN server, these parameters can be used to push subnets to
the client that need to be routed via the OpenVPN server. Used in conjunction with the
Push Mask parameter below.
Push mask #1/#2/#3
Used with the Push IP address parameter above to define subnets that should be routed via
the OpenVPN server.
Push DNS server address #1/#2
When configured as an OpenVPN server, these parameters can be used to push DNS server
settings to the OpenVPN client.
Pull interface IP address
When configured as an OpenVPN client, this option must be enabled for the router to obtain
and use the local IP address supplied from the OpenVPN server.
Pull routes
When configured as an OpenVPN client, this option must be enabled for the router to use
routes sent from the OpenVPN server.
Pull DNS server addresses
When configured as an OpenVPN client, this option must be enabled for the router to use
DNS servers sent from the OpenVPN server.
Packet replay ID window
When set to a non-zero value, this enables sequence number replay detection. It indicates
the number of packet IDs lower than the current highest ID to allow out of sequence.
Packet replay time window (seconds)
Set to a non-zero value to enable time tracking of incoming packets.
OpenVPN TX ping interval (seconds)
Interval between OpenVPN ping transmissions. These are required to detect the operational
state of the VPN connection.