User`s guide

197
Example
To setup multiple users in this way, first set up the Our ID parameter on the host unit to a
suitable name, e.g. “Host1”. Then set the Peer ID parameter to “Remote*” for example. In
addition, an entry would be made in the user table with “Remote*” for the Username and a
suitable Password value, e.g. “mysecret”.
Each of the remote units that required access to the host would then have to be configured
with an Our ID parameter of “Remote01”, “Remote02”, etc. and each would have to have
an entry in their user table for User Host1 along with its password (i.e. the pre-shared key).
Host Router
Peer ID: Remote*
Our ID: Host1
Username: Remote*
Password: mysecret
Remote Router 1
Peer ID: Host1
Our ID: Remote01
Username: Host1
Password: mysecret
Remote Router 2
Peer ID: Host1
Our ID: Remote02
Username: Host1
Password: mysecret
Remote Router 3
Peer ID: Host1
Our ID: Remote03
Username: Host1
Password: mysecret