User`s guide

181
When this button is clicked, the router attempts to load the file specified in the file selection
list box into the edit window below the button. The text in the window can be edited as
required.
Save Config File
When this button is clicked, the text in the edit window will be saved to the filename
specified in the drop-down list above. These three controls allow an OSPF configuration file
to be loaded, edited and saved.
Restart OSPF after configuration file is saved
When checked, this checkbox will cause the OSPF functions to restart once the edited
configuration file has been saved.
Restart OSPF if a fatal error occurs
When checked this checkbox will cause OSPF functioning to restart after a delay of 5
seconds if a fatal error occurs.
OSPF Tracing
In common with some of the other functionality of the router, OSPF supports some debug
functionality. The amount of information in the debug traces is controlled from this drop-
down list. The available levels are “Off”, “Low”, “Med” and “High”. Selecting “Off” disables
debug tracing.
Ignore MTU indications
All OSPF routers must have the same Maximum Transmitted Unit (MTU) and this value is
advertised in the OSPF packets. When checked, this checkbox will cause the router to ignore
received packets that have a MTU that differs from that of the router itself.
Use Interface IPsec source IP
When checked, this checkbox will cause OSPF functions to use the source IP address of the
interface specified in Configuration – Network > Interfaces > Advanced > PPP n :
Use interface x,y for the source IP address of IPsec packets on the interface being
used. When unchecked, OSPF will use the source IP address of the interface being used for
its source address.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
ospf 0 Enable on,off Enable OSPF
ospf 0 conffile OSPF Configuration Filename
ospf 0 new_cfg_rest on,off
Restart OSPF after a
configuration file is saved
ospf 0 fatal_rest on,off
Restart OSPF if a fatal error
occurs
ospf 0 debug
0 – 3
0 = Off
1 = Low
2 = Med
3 = High
OSPF Tracing
ospf 0 ignore_mtu on,off Ignore MTU indications
ospf 0 useipsecent on,off Use Interface IPsec source IP
BGP