User`s guide

174
Entity
Instance
Parameter
Values
Equivalent Web Parameter
def_route n ll_ent Blank,PPP,ETH,TUN Interface x,y
def_route n ll_add 0 – 2147483647 Interface x,y
def_route n upmetric 1 - 16 Metric
Advanced
Configuration – Network > IP Routing/Forwarding> Static Routes> Default Route
n> Advanced
Use metric n when the interface is not active
As per equivalent parameter in Routes n.
Use this route only if the source IP address of the packet matches
As per equivalent parameter in Routes n.
IP address a.b.c.d
As per equivalent parameter in Routes n.
Mask a.b.c.d
As per equivalent parameter in Routes n.
Include this route in RIP advertisements
As per equivalent parameter in Routes n.
Make PPP x interface use the alternative idle timeout when this route becomes
available
As per equivalent parameters in Routes n.
Wait for s seconds after power up before allowing this route to activate the
interface
As per equivalent parameter in Routes n.
If the interface is configured for “dial on demand”
Mark this route as “Out Of Service” if the interface fails to connect after n
consecutive attempts
As per equivalent parameter in Routes n.
If the interface fails to connect, try again in s seconds
As per equivalent parameter in Routes n.
Deactivate the interface after it successfully connects
As per equivalent parameter in Routes n.
Do not allow this interface to be activated by this route for s seconds after the last
activation attempt
As per equivalent parameter in Routes n.
Only queue one packet whilst waiting for the interface to connect
As per equivalent parameter in Routes n.
When this route becomes available, deactivate the following interfaces x,y x,y
As per equivalent parameter in Routes n.
When this route becomes unavailable, remove the “Out Of Service” state on x,y
As per equivalent parameter in Routes n.
Keep this route in service for s seconds after OOS state is cleared