User`s guide
172
Keep this route in service for s seconds after OOS state is cleared
When this checkbox is checked, the following text box is enabled (i.e. it is no longer “greyed
out”), allowing a value to be entered. The value specifies the period that the interface
specified above will remain in service even though it is actually unable to pass traffic
immediately. This is behaviour useful in situations where a PPP interface is activating and
traffic should not try the next interface until this one has been allowed a certain amount of
time to come up. When this timer expires, if the interface is unable to pass traffic, it will be
marked Out of Service and the next interface will be tried.
Assign this route to recovery group n
The value in this text box is used to assign the route to a “recovery group”. This means that
if all the routes in a particular recovery group go out of service, the out of service status is
cleared for all routes in that group. If one route in a group comes back into service, all
routes with a lower priority (metric) also have their out of service status cleared.
Related CLI Commands
Entity
Instance
Parameter
Values
Equivalent Web Parameter
route n metric 0 – 2147483647
Use metric n when the
interface is not active
route n srcip
Valid IP address
a.b.c.d
IP Address a.b.c.d
route n srcmask
Valid netmask
a.b.c.d
Mask a.b.c.d
route n inrip on,off
Include this route in RIP
advertisements
route n doinact2 on,off
Make PPP n interface use the
alternative idle timeout when
this route becomes available
route n inact2add 0 – 2147483647
Make PPP n interface use the
alternative idle timeout when
this route becomes available
route n pwr_dly 0 - 255
Wait for s seconds after power
up before allowing this route
to activate the interface
route n actooslim 0 – 2147483647
Mark this route as “Out Of
Service” if the interface fails to
connect after n consecutive
attempts
route n chkoos_int 0 – 2147483647
If the interface fails to
connect, try again in s seconds
route n chkoos_deact 0 - 255
Deactivate the interface after
it successfully connects
route n dial_int
0 – 255
Default 10
Do not allow this interface to
be activated by this route for s
seconds after the last
activation attempt
route n q1 on,off
Only queue one packet whilst