User`s guide

169
Entity
Instance
Parameter
Values
Equivalent Web Parameter
ip 0 routeup_dly
0 -
2147483647
When an “Always On” route
becomes “In Service”, wait s
seconds before using it
Static Routes
Configuration – Network > IP Routing/Forwarding> Static Routes
The static routing web pages and command line parameters described below control the
static routing table used by the router. These allow the setting up of static IP routes for
particular IP subnets, networks or addresses.
Route n
Configuration – Network > IP Routing/Forwarding> Static Routes> Route n
Each of the static route instances has its own configuration page. These are described
below:
Description
The value in this text box is to allow a memorable name for the route to be assigned.
Destination Network a.b.c.d
The value in this text box is the IP address of the destination subnet, network or IP address
for the route. If the router receives a packet with a destination IP address that matches the
Destination Network/Mask combination it will route the packet through the interface
specified below.
Mask a.b.c.d
The value in this text box is the network mask that is used in conjunction with the above
destination network address to specify the.
Gateway a.b.c.d
The value in this text box is used to override the default gateway IP address configured for
the Ethernet interfaces. Packets matching the route will use the gateway address specified
in the route rather than the address specified on the Ethernet interface configuration page.
This parameter does NOT apply to routes using PPP interfaces.
Interface x,y
The interface used to route the packets is selected from the drop-down list and the interface
instance number is entered into the adjacent text box. The available options are:
• None
• PPP
• Ethernet
• Tunnel
Use PPP sub-configuration
If PPP sub-configs are defined, this text will appear in normal highlighting (i.e. not “greyed
out”) and text box will accept the number for the desired sub-config to use on this route.
This parameter will not appear at all on those models which do not support PPP sub-
configurations.
Metric n
The value in this text box is the routing metric to use when the interface is connected. This
should have a value between 1 and 16 and is used to select which route should be used
when the subnet for a packet matches more than one of the IP route entries.